DSC Power608 Especificações descarregar pdf (Página 7)

G E T T I N G S T A R T E D

2.12 Keypad Zones

Each “z” keypad on the system has a zone input to which a

device - such as a door contact - can be connected. This saves

you from running wires back to the control panel for every

device.

To install the keypad, open the keypad plastic by removing the

screw at the bottom of the unit. Locate the five terminals on the

keypad circuit board. Connect the four Keybus wires from the

control panel: the red wire to R, the black to B, the yellow to Y

and the green to G.

To connect the zone, run one wire to the Z terminal and the other

to B. For powered devices, use red and black to supply power

to the device. Run the red wire to the R (positive) terminal and

the black wire to the B (negative) terminal.

When using end of line supervision, connect the zone according

to one of the configurations outlined in Section 2.8 “Zone

Wiring.” End of line resistors must be placed on the device

end of the loop, not at the keypad.

Keypad zones do not support DEOL resistors.

Assigning Keypad Zones

When using keypad zone inputs, each input used must be

assigned a zone number in Installer’s Programming.

First, ensure that you have enrolled all installed keypads into the

desired slots. (See Section 2.5 “Keypad Enrollment.”)

Next, enter programming section [020] to assign the zones.

There are eight programming locations in this section, one for

each keypad slot. Enter a 2-digit zone number for each of the

keypad zones. This number must be entered in the location

corresponding to the keypad to which each zone is connected.

Keypad zones 1-6 will replace zone terminals Z1-

Z6 on the control panel.

Once the keypad zones are assigned, you must

also program zone definitions and zone attributes.

(See also Section 5.4 “Assigning Keypad Zones”).

1 2 3 4 5 6 7 8 9 10 11 12 ... 51 52

Sem comentários

DSC Power608 Especificações Página 7