DSC WLS920 Manual de Instalação descarregar pdf (Página 8)

3.1 Hardwire Connections (Power and Telephone)

There are four jacks located at the back of the unit: one TYPE jack for the AC connector, two telephone jacks

(one Telephone In; one Telephone Out) and one RJ-38A jack for a hardwired telephone connection.

To connect the power, plug one end of the AC power adaptor to the round jack at the back of the unit. Plug the

other end into a wall. This connection will provide power to the unit.

To connect the telephone line, run a telephone cable from the wall to the Telephone In jack on the unit. To

connect a telephone to the unit, run another telephone cable from the Telephone Out jack to the telephone.

Consult the connection diagram below for further instruction.

3.2 Adding Wireless Devices

The following is the procedure for adding wireless transmitters:

1. Enter Installer’s Programming and enter Section [804]

2. Enter the 2-digit zone number for the device ([01] to [08]).

3. Enter the five digit electronic serial number located on the back of the wireless device.

The device is now added to the panel. Continue with steps 2 and 3 until all of the wireless devices are added.

Press [#] twice to exit Installer Programming.

You must also program how the zone will operate.

See Section 5.1 “Zone Definitions” for more information.

Adding WLS909 Wireless Keys

Wireless keys are assigned in programming section [804], subsections [41]-[56]. Enroll each wireless key by

entering the serial numbers on the back of each unit as indicated in steps 2 and 3 above.

3.3 Deleting Wireless Devices

To remove a wireless device from the panel, follow the guideline for adding a wireless device. Program

the serial number as [00000]. The wireless device for the zone will be removed.

You may need to power down the panel to clear troubles caused by deleted zones.

Installation Steps

Section3

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 31 32

Sem comentários

DSC WLS920 Manual de Instalação Página 8