DSC PC6010 Manual de Instalação descarregar pdf (Página 25)

PGM Pulse Times

This section will allow you to select the amount of time a programmable output will remain active, after

being triggered.

NOTE: The system will reset the outputs when a user attempts to clear alarms, regardless of

whether or not all the alarms are cleared.

The main bell, switched auxiliary or any of the PGM outputs programmed for “Utility Output” and

“Sensor Reset”, can be active from 000 to 255 seconds. The default setting is 005.

Any output programmed for “Chime Pulse” can be active from 000 to 255 seconds. The default setting is

002.

Any output programmed as Duress Output for the selected area will activate for 000 - 254 minutes. If you

program 255 for the Duress Pulse time, the output will latch on, until a user enters an access code. The

default Duress Pulse time is 005 minutes.

NOTE: The Duress Pulse timer will follow the minute rollover. This will cause the Duress Pulse time to

be less than one minute in most cases. It is recommended that a Duress Pulse time of more than 1

minute be programmed.

SYSTEM AREASYSTEM AREA

SYSTEM AREA

PGM OUTPUTSPGM OUTPUTS

PGM OUTPUTS

PGM PULSE TIMESPGM PULSE TIMES

PGM PULSE TIMES

(5)(5)

(5)

UTILITY/SENSORUTILITY/SENSOR

UTILITY/SENSOR

(0)(0)

(0)

CHIME PULSECHIME PULSE

CHIME PULSE

(1)(1)

(1)

DURESS PULSEDURESS PULSE

DURESS PULSE

(2)(2)

(2)

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 51 52

Sem comentários

DSC PC6010 Manual de Instalação Página 25